📚 Learn more about The Shire's history on our Timeline. 🕰
Commands that I’ve noticed aren’t working correctly.
Smoot
Member, Engineer, Wiki Editor
/speed
//replace 0 38:1 (or any of the other flower IDs that go through 38:1 - 38:9)
//sel poly (will not allow for large selection)
//rg define [name] (I’m just going to assume that if this isn’t working, there is a chance other region commands aren’t working, but I haven’t tested.)
*if I find any more, I’ll post them here on the support forum*
//replace 0 38:1 (or any of the other flower IDs that go through 38:1 - 38:9)
//sel poly (will not allow for large selection)
//rg define [name] (I’m just going to assume that if this isn’t working, there is a chance other region commands aren’t working, but I haven’t tested.)
*if I find any more, I’ll post them here on the support forum*
Post edited by EnderKilla on
Comments
-
For //sel poly, anything over 21 points wont work, it'll select up until then but no further
/rg define [name] also doesnt work with //sel cuboid if that means anything, but it's probably an overarching issue instead of something to do with how the area is selected
/b # is also limited to 10Post edited by CoffeeAndChill on -
-
-
//rg define [name] (I’m just going to assume that if this isn’t working, there is a chance other region commands aren’t working, but I haven’t tested.)/rg define [name] also doesnt work with //sel cuboid if that means anything, but it's probably an overarching issue instead of something to do with how the area is selected
Resolved.
-
Smoot wrote://sel poly (will not allow for large selection)
-
John117 wrote:/b # is also limited to 10
-
For viceroy /top and /tppos nolonger work
-
//superpickaxe is not working for me right now
-
No /weather for viceroy anymore
-
Use pweather
/weather I believe has traditionally been artisan/archduke+ -
This discussion has been closed.